|
|
#151
12-29-2013, 03:37 AM
|
|||
|
|||
Just so everyone knows, it was not working when I tried it today. It just wasn't locking on to the test target. I didn't wait fifteen minutes like the instructions say, didn't wait at all, so maybe that was part of it. It was cold, too.
Also, I thought I was running at "4" power setting the other day, but I looked at the dial and it was set on "3". I tried "4" the other day after I made that post and it was too much. I could not isolate the target from the other noise. 
|
|
#152
12-31-2013, 03:58 AM
|
|||
|
|||
|
Installed a new trim pot today. It did not help very much. Obviously I don't have much electronics knowledge. I suspect I need I different value capacitor, but I did order a precision pot and I'll try that.
|
|
#153
01-06-2014, 11:28 PM
|
|||
|
|||
|
I got the precision pot, replaced one of the trim pots with it so it is outside case and it helped. So now I have one channel that is adjustable frequency. I just have to carry a frequency counter with me. It's still pretty touchy and the freq bounces about a tenth of a hertz. The weather is cold and windy today so I didn't get much time to work with it but it should work okay.
|
|
#155
05-15-2017, 01:30 PM
|
|||
|
|||
|
Haven't done anything with it except a new battery. Think I even salvag d the pot for another project.
|
|
#157
05-16-2017, 04:31 PM
|
|||
|
|||
|
Long answer, no.
|
|
#158
05-17-2017, 01:40 PM
|
|||
|
|||
|
This thread is ten years old. Wish I could say I am richer. Sure feel older.
|
 |
|
|
Linear Mode
