![]() |
|
#1
|
||||
|
||||
![]()
Dear friends!
Please electronics specialists and experienced members of this forum to establish their pattern of VLF receivers that should have the following characteristics: - Power supply - 9V; - Antenna - Telescope; - Compact; - Band Selector: ELF (3Hz-30Hz); SLF (30Hz-300Hz); ULF (300Hz-3KHz); VLF (3KHz-30KHz); LF (30KHz-300KHz). Does anyone have this shematic of VLF Reciver? Do any of the more experienced electronics can create such a VLF scheme Reciver and placed on this forum? Hoping not to ask too much, all the members of this forum I wish good health in the new 2012th year!!! Regards! Sneshko |
#2
|
||||
|
||||
![]() Quote:
if you really want to receive something on those bands, then forget on telescopic antenna: 1st reason: you cannot tune usual telescopic antenna to most of mentioned band (conditionally on 300kHz). 2nd reason: telescopic antenna is not directive antenna so worthless to detect something in some direction. But if you need only a virtual receiver, then telescopic antenna without any circuit will be enough. On lower bands you need a huge filtration to not be disturbed by power line (50Hz and its harmonics). On higher band you need signal down-conversion if you wish to get hearing audio. What sort of antenna then you need?: Air coil antenna or better ferrite core antenna. But you can build broadband receiver covering all your bands as you can read here: http://www.techlib.com/electronics/VLFwhistle.htm Again: to detect direction of incoming signal, you need directive antenna which telescopic antenna is not!
__________________
Global capital is ruining your life? You have right to self-defence! |
#3
|
||||
|
||||
![]()
You can modified circuit presented here:
http://www.longrangelocators.com/for...ad.php?t=18419 this way:
__________________
Global capital is ruining your life? You have right to self-defence! |
#4
|
||||
|
||||
![]() |
#5
|
||||
|
||||
![]()
If you insist, you can still connect, without harm or tangible benefit, additional telescopic antenna this way:
__________________
Global capital is ruining your life? You have right to self-defence! |
#6
|
||||
|
||||
![]()
these circuit semms ok, very simple anybody build this?
|
#7
|
||||
|
||||
![]()
happy new years guys! jaja
|
#8
|
||||
|
||||
![]()
Yes...
This is a basic VLF receiver which will tune a big range of VLF frequencies without difficult filters to keep narrow bandwidth. This is exactly what LRL experimenters want... ? A tuner that will tune VLF frequencies and will also tune RFI interference and 50-60Hz hums, and other external noise, including treasure noise? The best part of this design is it is easy to build, and it works for experimenter purposes better than difficult tuners with notch filters and other circuit enhancements that cause the tuner to receive only the frequency that is selected. What more could an LRL experimenter ask for? The only improvement would be maybe a goose that lays golden eggs... ? Best wishes, ![]() J_P |
![]() |
Thread Tools | |
Display Modes | |
|
|