PDA

View Full Version : Electroscope Model 20


Napsterce
06-06-2016, 11:11 PM
Hello everybody,
I need some schematic for the Electroscope Model 20, it "used" to find golden rings and stuff but it wont any more. Inside there are 3 small circut boards without any logical connection between them. I am more into making a new board, if you have some ideas feel free to tell'em. Thanks in advance.

Carl-NC
06-08-2016, 08:19 PM
Inside there are 3 small circut boards without any logical connection between them.

What you found is typical for Electroscope. The device is just a dowsing rod, nothing more. Over the years they've stuffed a variety of 'junk' inside, including boards that don't do anything but look somewhat technical to the casual observer.

You're lucky to have boards, many units I've seen have nothing but a massive rat's nest of wire stuffed inside. Since the boards are just for show, there is nothing to repair, and no need for a schematic since it would be nonsense anyway.

reza vir
06-09-2016, 12:44 PM
Hello everybody,
I need some schematic for the Electroscope Model 20, it "used" to find golden rings and stuff but it wont any more. Inside there are 3 small circut boards without any logical connection between them. I am more into making a new board, if you have some ideas feel free to tell'em. Thanks in advance.


http://www.geotech1.com/pages/lrl/reports/escope20/schem1.jpg

http://www.geotech1.com/pages/lrl/reports/escope20/schem2.jpg

http://www.geotech1.com/pages/lrl/reports/escope20/modulesch.jpg


http://www.geotech1.com/pages/lrl/reports/escope20/phasersch.jpg

Napsterce
06-09-2016, 02:12 PM
Thank you, i'm thinking about building Franco's lrl and put it in the box from the elctroscope.

sirnon
07-14-2016, 08:32 AM
Napsterce
Have you bulit the electroscope?

Napsterce
07-14-2016, 01:10 PM
I have one, it was given to me to "check" it. Inside there is a small pcb with 3 tantalum capacitors, one ceramic capacitor, couple of resistors and two transistors without any code on them. Now about the interesting part, in the schematics by reza vir, also found on geotech site there are two quartz capsules and they are not quartz capsules. After opening them i saw two plastic plates with a wire coming out. After cuting the plastic in half there was gold. In one there was golden coin with some spanish emperor on it and in the other capsule there was piece of gold. When selected "gold" power (9 volts) is coming to the capsules and i belive that it creates some kind of field which interracts with the phenomenom from the burried gold and it actualy reacts on something. Not tested with gold because i dont have test field yet but there is some chance that it will find gold (before anyone jumps in conclusion that i am talking b****hit, in similar way are working L rods and mfd locators).

sirnon
07-14-2016, 05:50 PM
Thx Napsterce;
Can you guide me to start making it
Can you help me with circuit diagram and electronic components and print cuirut for it

Napsterce
07-20-2016, 02:06 PM
Sirnon in my opinion it is better to build Franco's lrl, i have built it and it gives some results. Not yet used in treasure hunt, only on tests.

sirnon
07-22-2016, 08:35 PM
Sirnon in my opinion it is better to build Franco's lrl, i have built it and it gives some results. Not yet used in treasure hunt, only on tests.

Ok thx man