maybe clone mcu pd

[ayoni03]

ferrite coil and coil in the device and the sensors reflects the byte stream on the LCD screen.

[ayoni03]

hi,

[ayoni03]

ok

[abdou2014]

Thank you nice gift :D

[Geo]

Hahahaha.....
Alonso's PD with a lcd screen in place of buzer....
What will i see yet.....:angry:

[ayoni03]

Thank you nice gift :D
tahanks abdou2014..

[ayoni03]

Hahahaha.....
Alonso's PD with a lcd screen in place of buzer....
What will i see yet.....:angry:
hi,geo...Bravoooooooo
you know ....
yes alonso clone the PD.
yes alonso clone the PD.
alonso part of any analog circuit. But hex code mast be change..
regards..

[ayoni03]

ı think,

I think Franco 's 4046 LCD screen frequency adjuster ....with mcu..better 64 bit arm cortex3 mcu...

[Geo]

hi,geo...Bravoooooooo
you know ....
yes alonso clone the PD.
yes alonso clone the PD.
alonso part of any analog circuit. But hex code mast be change..
regards..

No reason for MCU.
One 555 with a led and a buzer and it's ok

[ayoni03]

No reason for MCU.
One 555 with a led and a buzer and it's ok

it is not enough.
alonso is calibrating device already difficult.

To measure the frequency is very important .

[Geo]

No need to measure frequency because is not so important

[Geo]

Also as it is connected it is not measure frequency because it is connected after the diodes...

[ayoni03]

Also as it is connected it is not measure frequency because it is connected after the diodes...

What would you recommend looking for a solution .

[ayoni03]

remove diodes.

[ayoni03]

this is franco 4046 pll lrl modification

[abdou2014]

do you have simplified version without pic

[ayoni03]

do you have simplified version without pic

unfortunately

[ayoni03]

2. modification

[ayoni03]

v3 atmega 8 very very stable ..........

[ayoni03]

sorry my english very bad..ı use google translate..
Franco brother too thank this forum to share loving presence .of my brother ... Franco ...
İf you want...
I can share with you ...
Please email address you pine ... full 4046 mcu v3 project only pcb smd...and softvare ...hex code..
King Regards.....

[ouiarabe]

v3 atmega 8 very very stable ..........

Hello
please can you provide us thé hex file of atmega8

thank you in advance

[ayoni03]

Hello
please can you provide us thé hex file of atmega8

thank you in advance



maybe later..
regards...

[ayoni03]

divice runing .....

[ayoni03]

very good
stability....
smart oscillation....
caunt frequency...
automatic pll...
ready target...

[abdou2014]

nice work !

[ayoni03]

I think so....

[ayoni03]

I do not see pictures why .....

[Treasureshunter]

I do not see pictures
Wwwwwwwhhhhhhhyyyyy???????????