PDA

View Full Version : Output Circuit of PI metal detector


kazem2114
05-30-2012, 03:04 PM
Hi guys
I simulated the output of my "Luminous 15000 metal detector"
but I am a little bit confused of output waveforms.
my detector is a "PI detector" and it doesn't work and I wana fix it...
"IRF840" is on just for 200usec
Does it mean that my LOOP just search for only 200usec
What I expected to see was that "IRF840" be on for (1-td)
but now it's on for td=200usec
and approximately how much current according to ICs is going to coil(=LOOP)?

Please explain how this part works...
Thanks

michael
05-30-2012, 07:56 PM
I'm astonished, why Qiaozhi doesn't transfer all of this guy posts about PIs to Geotech forum?:???:
These comments don’t belong to here. This should be done for this thread and " Finding An IC " thread. Don't you agree?

Qiaozhi
05-30-2012, 11:36 PM
I'm astonished, why Qiaozhi doesn't transfer all of this guy posts about PIs to Geotech forum?:???:
These comments don’t belong to here. This should be done for this thread and " Finding An IC " thread. Don't you agree?
You beat me to it!

Hi guys
I simulated the output of my "Luminous 15000 metal detector"
but I am a little bit confused of output waveforms.
my detector is a "PI detector" and it doesn't work and I wana fix it...
"IRF840" is on just for 200usec
Does it mean that my LOOP just search for only 200usec
What I expected to see was that "IRF840" be on for (1-td)
but now it's on for td=200usec
and approximately how much current according to ICs is going to coil(=LOOP)?

Please explain how this part works...
Thanks
kazem2114 - The best place to post your questions is at http://www.geotech1.com/forums/index.php
Go to the Tech Forum and start a new thread there.
The LRL Forums are for ... well ... LRLs (what else?), not conventional PI detectors.